Klantbeoordelingen voor VEVOR benzine-aangedreven snoeizaag met 43cc 2-taktmotor, kettingzaag met draaibare kop, telescopische zaag met uitschuifbare steel van 2,16-3,66 m, zaagblad van 25,4 cm, brandstoftank van 850 ml, voor het snoeien van bomen.

Het effect is langdurig zonder frequent herhalen nodig. Bespaart veel tijd en geld elke dag!

Het is extreem makkelijk in gebruik, geen ingewikkelde stappen. Zelfs mijn opa gebruikt het zonder moeite!

De structurele stevigheid is uitzonderlijk, geen vervorming zelfs onder zware druk. Zeer duurzaam!

Het is ongelooflijk praktisch voor dagelijks gebruik, het heeft me veel dingen vereenvoudigd. Nu kan ik er niet meer zonder!

I purchased it to cut top of the trees that I could reach with my 2m pole saw. It has done the job perfectly. Good points - price, easy to start, good chain, thick poles. Bad points - it is very heavy, some parts feel very cheap but that to be expected, manual could be better. Overall it was a good buy

Assembly was difficult. Whilst the extension poles would easily click together (into each other) none of them would fully click into the first (engine) pole. The inner shaft of the first pole was about 7mm too proud (recessed by about 17mm instead of about 24mm) preventing another pole from being fully engaged. Dismantling the motor end of this pole and reseating the inner shaft fixed the issue. On first attempt the engine was difficult to start. Locking the throttle lever in the fast idle position didn't seem to do anything. By looking through the slots on the engine cover I could see that the throttle lever was not actually moving the lever on the carburettor. Dismantling the handle, I found that the throttle cable was not engaged in the throttle lever. I corrected this and was able to start the engine. Both these problems were on parts that were already assembled before delivery so poor quality control. The saw functions as it should and does the job.

The saw started very well, and has good power. After about an hour of use, the power head stop working. I did enjoy using it for the short time it ran, I'm just hoping that vevor will send me a replacement without any hassle.

Pole saw worked well after carefull assembly , translating the instructions from the Chinese manual to see the full instructions, you need to use lithium grease on the driveshaft splines and the head unit grease fitting , this is not on the English manual. After some days of use the pull start broke , see the pictures. VEVOR please send me a replacement pull start assembly and I can fit it myself.

The pole saw has worked well for me, takes a good few pulls of the cord to get started. 2 things I don't like are, the choke is very close to the pull cord handle, and when separating the extension poles, the inner rods come out also.

El envío fue muy rápido, antes de finalización de plazo. El paquete debía incluir el bidón pequeño para realizar la mezcla del combustible, pero lamentablemente faltaba.