Klantbeoordelingen voor VEVOR Airless muurverfspuitpistool met hogedrukbuis, hogedrukspuit, 2000W muurverfspuitpistool Verfspuit voor binnen- en buitenverven op water- en oliebasis

Not very even spray pattern, hard to prime pump and difficult to follow instruction.

Works OK so far.... some design issues, just lazy engineering.... shipping was ABSOLUTE CRAP.... sat for a week in Houston/ Dallas.... I don't need a $500 sprayer, so this will work. Customer service is non-existent.... can't expect much....

Das Preis/ Leustungsverhältnis ist in Ordnung. Leider gibt es bei Vevor keine Ersatzteile, oder Zubehör. Sehr schade, weil ich Feinfilter im Netz bestellt habe und feststellen musste, das die gekauften Standardfilter nicht in die Pistole passen.

Kit com avaria, já contatei equipa de apoio ao cliente.

ME FALTA PROBARLA PERO LA PRIMERA SENSACION ES BUNA

Great tool works great, had issues with nozzle, i send message for customer service never hear back from them after

I used this to put primer on Sheetrock.,it really puts out a lot so tap up everything and move steady. If I over lapped, I had runs.,it also will use twice as much primer than if you roll it on. It’s way quicker to spray if you prep good with plastic and tap. So if you’re in a hurry and money is no object. I loved it. I rolled on the paint because it was getting expensive. But it really did a good job.

La máquina viene golpeada y rota en una esquina. Parece como por aplastamiento o algo que ha presionado mucho la caja. Teniendo en cuenta el tipo de plástico que lleva en la carcasa del motor, el golpe/presión no ha debido ser pequeño. De todas formas, el embalaje interior para protección es muy escaso, de baja calidad y en esa zona en especial es inexistente. En cuanto al uso, ya iré comentando. Mal hemos empezado. Un poco decepcionado.

Unfortunately this was a bad purchase, only used it twice once to paint and once to stain ,cleaned it out very well as I've done with my Magnum 1500 ,also had to purchased another unit but it was a Titan 440 ,to finish the job...for some reason it's stuck in the primer cycle....but oh well .....it's junk now!!!!

I'm still disappointed. The quality is poor; the ball was jammed by a piece of plastic inside, so I wasted hours trying to find and fix the problem. The return line doesn't stay in place, and the main line pinches easily. The nozzle is also poor quality, the paint is more concentrated at the edges of the spray, which creates strips (regardless of pressure or mixture), and most importantly, the flow isn't continuous! You have to adjust your movement, going slow and fast in rhythm with the machine. The extension tube is useless because when you release the trigger, the time it takes for the pressure to decrease in the extension tube creates a concentrated spray of paint on the wall or ceiling (my technique is to quickly point the nozzle towards the floor before releasing the trigger).