Klantbeoordelingen voor VEVOR 52cc benzinekettingzaag, 455 mm kettingzaag, 2,4 pk zaag met antisliphandgreep, dubbele brandstoftanks en noodstopfunctie, max. 11.800 tpm, voor houtkap, snoeien en ruimen van bomen

The saw works just as advertised. Used it now for over 6 hours. Works great. Great value

I’ve cut down 3 trees and cut them up for firewood. I put it through its paces and it has run flawlessly. You can’t beat the price for a 62cc chain saw. I have 3 purchases on Vevor and everything that I bought has been good quality for a low price….no complaints!

Not the quality I would expect fron Vevor! I have purchased a few things from Vevor and found them to be of a higher quality at a great price. First the cons: Blade break is attached to the side plate. Makes it harder to remove the plate when changing chains. Blade plate screws are in a recessed channel. While a slight recess is needed to protect the screws, this is overkill. Screws can't be accesses with gloves on. Chain bar can only be installed in one position. For even wear, the bar should be flipped when changing chains for even wear. This bar only has 1 tensioning whole and oil slot so bar cannot be flipped. Tention screws mounted next to bar. Very hard to access the chain tightening screw as it sits very close to the chain bar. Chain oil reservoir cap recessed and small. Can't access with gloves on, and fill from a gallon of bar oil without a funnel. Floods easily. Saw floods easily and becomes very hard to start. Pros: As Doug M says "it will cut!" This chain is very sharp. It will cut like it eats wood. For the price, once you get it started it works very well.

For a small saw, comes in handy. i'm 84 years old and this saw fits perfect for pruning and trimming small bushes along my 1/4 mile driveway.

Für den günstigen Preis eine wirklich tolle Säge. Sie ist schnell und einfach zusammengebaut und hat die ersten Kubikmeter Brennholz mit Bravour gemeistert. Man kann die Säge nur weiter empfehlen.

Very strong and nice saw It has only one problem it’s leak lil chain saw oil if u don’t finish off other then that everything work so well

I received my package a day earlier. Put it together, ready to go use it. Very pleased so far.

The chainsaw was exactly what I was expecting from Vevor. I have yet to get anything from Vevor that has not been study and well made. It is loud but I was expecting that and it cranks on the first try after the instructions on the saw. Great Chainsaw!!!

Cant argue with the price, with my comparable saws being in the 500-800 range. Heavier, and louder than stihl or husqavarna and doesn't have the motor behind it, but great for the average homeowner or a limbing saw. Hate the chain adjustment port, wish this also came on the side plate instead of parallel with the bar, but I can't complain at the price.

First off, let me say that for the price, I am very pleased with this saw. I was not too sure if I was going to like the chain adjustment setup, but I found that I did like this method. I now do not have to stop and get tools to adjust the tension every time to do this adjustment. There are, however, a few things that I would like to see incorporated for the future. The place where you put your foot to stabilize the saw when starting is a little bit on the small side. Someone with a larger foot would not be able to get their shoe in there and you really need to be able to do this to start the engine. Next, if you use the saw for a while and then stop for 10 or so minutes, it is extremely hard to start it again. I believe what is happening is the fuel in the carb is evaporating and you have to pull the starter rope quite a few times to get fuel back into the carb before it will start again. If this saw had a primer bulb on it, you could get fuel into the carb without all of the pulling on the starter cord making restarts much easier. The first time I tried tor run the saw in a horizonal position, it died shortly after starting the cut. After having the same issue a second time, I opened the fuel cap and sure enough, the fuel filter was caught up by the filler. When the saw was horizonal, this meant that it was fuel starved. Just freeing the filter took care of that issue. So for the money, I am happy with this saw. For the occasional user / homeowner, this will work fine, this is the target audience.