Klantbeoordelingen voor VEVOR 52cc benzinekettingzaag, 455 mm kettingzaag, 2,4 pk zaag met antisliphandgreep, dubbele brandstoftanks en noodstopfunctie, max. 11.800 tpm, voor houtkap, snoeien en ruimen van bomen

Only tried it once so far. I bought it as a backup saw

This was a bigger bargain than I expected. Once we put it together and added fuel it fired right up.

I’ve owned a number of souls personally as well as being a fleet manager for a lawn care company purchased them all and repair them all and I’m telling you the V were chainsaw for the money they charge can’t be beat. I’m not saying it’s the best salt on the market for the money. I don’t see an argument.

This is a good little saw,easy to hold with one hand which frees up your other hand to process the small limbs into stove length sizes.

Hard to beat for the price. Is it as good as a Husqvarna 450 that costs over 4 times as much? No, but it's better than it has any right to be for $109.00 and it's good enough for what I need it for. My only major complaint is the chain tensioner screw. It's not in the most convenient location, and I suspect that the plastic screws it uses will need to be replaced at some point. That said, I'm happy with it.

This saw is as good if not better thann any saw i have bought and by far the very best price I have bought. I will be purchasing the 62cc saw to replace my Husqvarna. I highly recommend any saw thay have, I also bought the pole saw..

Très bon article, fait le job.

Pulled it out of the box put it together fired it up and cut down a tree! Great chainsaw!

Very happy with the purchase. Would recommend to all my friends.

The saw comes with everything you need except gasoline, 2-stroke oil, and bar oil. Bar and chain assembly is quick, as are tension adjustments. Comes with a tiny gas mixing container to measure, mix, and store 1 1/2 tanks' worth of gas at a 40:1 ratio. Stock Torch L7RTC plug is compatible with an NGK BPMR7A plug. Replacement chains are easy to order, an Oregon 21BPX076G for instance. Any 0.325 pitch, 76 link, 0.58 gauge chain. Be advised that the engine can flood easily when pulling with the choke on. Use the choke only until you hear it begin to catch on a pull, then start it with NO CHOKE. If you flood it, remove the plug, dry it, hold the saw upright, and give it a few pulls to purge the cylinder, re-install the plug, and start it with no choke. It will smoke on first start-up due to oil treatment of the cylinder at the factory. The whole saw with chain is less than the cost of 5 chains- a real bargain. It's loud, wear ear protection. They thoughtfully included two sets of ear plugs.