Klantbeoordelingen voor VEVOR 37,77cc benzine T-paalrammer, 4-takt benzinemotor hekpaalrammer met 2 paalrammerkoppen (55/70 mm), draagbare 1000W paalrammer voor boerderijen, ranchhekken en wegverbeteringen

Used the JH95 to drive 2" ID Schedule 40 pipe. On the 4th pipe, bolts around the base fell out. We put the back in and torque tighten them. 3 pipes later, they are falling out again. On our 8th pipe, the exhaust pipe fell out of the muffler. 11th pipe, one of the bolts mounting the handle bars to bottom frame fell out, other was near falling out. By the end of our driving of 19 posts. We were tightening bolts before a 2 times during driving each pipe. The base holes are ovaled now and will not line up properly. Also, you cant throttle over half pull because the engine RPMs are not synced correctly with the driver. Overall, we barely got done what we needed done before this driver became none operational. Minimal technology put into this driver. Very pour quality with lock washers, and materials used on the driver side. Minis the muffler exhaust pipe falling off. The engine ran fine. Choke stickers are backwards on both the drivers we bought. Seems to be a common issue as others have said the same with no correction of the issue. Highly disappointing, misleading description, and just plain disgusted with this piece of equipment.

Had a very difficult time getting this started. Once it did start, it did not want to stay running once the throttle was pushed. I was able to use it for a total of about one minute, because it would not stay running. I also received the item with a cracked and broken case.

Bought the 4 stroke post driver worked for a month and stopped hammer, tried warranty but was just given the run around and was told to send pointless video after video. Do not recommend

Ordered two units, just in case one broke. Both units failed within two days of light usage. I purchased these because of how much cheaper than the Honda unit, but this entire process was totally unacceptable! I spent half a day trying to post a video and request a refund, but gave up....

Hammer plate broke in half on 10th post trying to talk to someone in turning into a nightmare.

Did not have power to drive a single t post.. drove 10 posts manually faster than this could do one in soft soil.

Don't waste your money on it comes apart and the ram want stay on the cylinder had to weld it to get it to drive the post

Followed the instructions exactly but after first use I haven’t been able to get to start again. Even when it was running it didn’t really work on t-post . Wouldn’t recommend

Purchased the 52cc gas powered pole driver. After driving a single 24” into the ground until went to chattering, shut it down, inspected the bottom section and found a broken mandrel. Website will not allow me upload a picture. I have sent notice and requested a replacement, let’s see how that goes.

This product is absolutely worthless. It is also very difficult to get a refund with this company's non-human contact. It took 2 weeks to get a refund with no one to talk to I finally had to dispute it through my credit card. Now we're continually getting emails and harassment over this product. Do not recommend this company or this product order for a.