Klantbeoordelingen voor VEVOR 2x palletvorken klembaar 1490x100x230 mm vorkenbord 1814kg laadvermogen vorken 149cm totale lengte met 109,2cm vorkblad heftruck heftrucktanden voorlader palletframe

Item came as pictured, when unboxes i seen the box profile was 3mm wall, i expected 5-6mm wall for the rated weight it should handle, i will be welding on some flat to the sides for extra strength. The first time i used them the bolts to tighten to the bucket bent due to the gap allowing too much movement. I again will need to modify the gap and update the bolt size. Nice idea for a product but in my opinion as standard only fit for very light use.

Good product for the price and they work well. Only complaint is they do slide around your tractor bucket and don’t stay straight even when secured well.

I bought these forks because they looked like a perfect fit for my New Holland tractor. Looked perfect when unpacking however I ran into a problem. When trying to attach my lower control arms I found the holes drilled on the bracket were too close to the frame of the fork attachment. I could not put the pin in, the holes should have been an inch farther from the frame. Not sure if I should return or remove and weld on new steel brackets that are a little longer. I willl attach the picture. I the lower arm will be beside the bracket for the picture to show distance is not large enough

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

attache sur les bras de relevage trop courte, attache des fourche trop fragile

If I had it to do all over I would bought the ones that are connected but I just welded a piece of pipe to mine. They serve there purpose but the will shift one you no matter how tight you get them.

Quality of steel forks are really good but the center likes to pop out sometimes. If they made the center a little more steady it would be pretty good product.

Need some other way to hold them on. The clamps bent rite away.

Received the item and the bolts needed for the lower link were missing instead there were pins. This absolutely is incorrect I had to buy additional bolts to use for the lower link

They are a pain in the A## to use, always slipping, even with a plate under the hold down area, they bent my bucket. I will be welding them permanently to a plate