Klantbeoordelingen voor VEVOR 2x palletvorken klembaar 1490x100x230 mm vorkenbord 1814kg laadvermogen vorken 149cm totale lengte met 109,2cm vorkblad heftruck heftrucktanden voorlader palletframe

Although I haven't used them yet they are very well built and solid, very good quality and they should suit what I need them for and then some.

Acheté pour équiper un mocro-tracteur, très satisfait de cet achat de très bonne qualité, monté en moins de 10 minutes. Généralement je fabrique moi même mes outils mais vu le prix cela ne valait pas le coup de m'y atteler. Le seul bémol pour un tracteur ( je m'en doutais avant achat) c'est qu'il faut modifier le 3eme point sinon la barre réglable finie par venir buter sur l'angle du châssis et plier si l'on n'y fais pas attention.

Forks are built good for the rated weight they can handle. Easy to put onto bucket. The hold down bolt is weak and bends easily and one of the bottom nuts fell off on mine while loosing the bolt from the bucket, the lock tight used to keep it on broke loose allowing the nut to unscrew from the bolt. I drilled a hole through the nut and bolt and installed a roll pin to fix it. Works great now

Everything is good I just wish the screws to hold them in place had something where you can use a wrench to get it tight other than that great product.

The forks work well and I enjoy the fold up deign when not in use. I have used them to pickup pallets weighing as much as 1850 lbs. Repeated use with heavy loads quickly leads to metal fatigue deforming the tube steel and cracking the welds. This tool is best used for light work or will require additional reinforcement to repeatedly handle the load rating specified by the manufacturer.

Arrived on time. Very easy to install and remove. They work as described and are a great addition to my tractor

Très pratique, surtout les fourches qui se replient, dommage que les 2 platines pour accrocher le 3ème point soient soudées en sens inverse. L'axe est en biais, à part ça , super.

For the price, hard to complain. But if asked I would say the bolts that hold the forks to the bucket are hard to keep tight. If they get loose and you don't catch it, it could cause all kinds of problems. I would rather have bolts with hex heads, and likely will replace them later, so I can tighten easier with a wrench.

Over all I like these forks. After several times using them, there’s something I would change with the clamps. You have to use a cheater bar to get them tight and the threaded rods that’s bent over as a handle interfere with each other. The solution I’m going to implement is cut off the bend on the rod and weld a large nut to the to the top. Then a wrench or socket could be used to tighten each rod. Otherwise I’m very happy with them

Works good, but 1 fell off during operation when backing out of pallet. Othwlerwise I am happy with them.