Klantbeoordelingen voor VEVOR 2800 W Verstekzaag met cirkelzaagblad, 35,5 cm, Professionele paneelzaag, Verstekzaag, Zagen, Verstekzaag, Cirkelzaag, Hoogwaardig zaagblad, Verstekzaag voor koud zagen, Oranje & Zwart

The base of the unit I received was warped from the factory. A part sitting in the clamp can rock back and forth up to 2 degrees with no way to know if the cut will be square. Because it is warped directly under the blade, the free end of the cut has a possibility to bind on the blade as the cut progresses. Additionally, the angle adjustment is inaccurate. The angle adjustment pivot has something like 1/8" of play so you could never make a miter you could trust to be reasonable accurate to build with without measuring the angle by hand somehow. Both of these problems would be easily fixed if the company would accept the defect in the product but I contacted Vevor about the defect and this is their response: "The base has a slight curve: This is due to the base's thickness, but it does not affect the balance of the cutting process. Cutting angle issues: With any machine of this type, accuracy is limited, not precision." Its surprising to see such an obviously problematic defect dismissed as acceptable by the company. They company will not accept a return for the saw and they offered me first a $25 refund then a $75 refund to help cover the cost to repair the base. I guess I'll be designing a new base for this before I can use it. I didn't have high precision expectations given the low cost of this saw but if you want to make reasonably square cuts, I'd look at one of the other options.

I spent extra to get the better saw and got something with very poor build quality. When you start the saw it sounds awful, like it’s rubbing but nothing is visible. When you bring the blade down to cut it almost rubs on the right side of the cutting channel. I cut one piece of material and it went OK but on the second piece as the blade was cutting it hit the side of the cutting channel and the entire saw jumped out of my hands. It hit hard enough to bend the original blade. I purchased the more expensive blade with more teeth but after installing it I’m not willing to use this is again, it’s dangerous with the blade coming down so close to the side of the cutting channel. I should have looked this over more carefully when I first received the saw and sent it back. What a waste of $300 so beware. Check your saw thoroughly. I know some of you got decent saws, mine is junk. This is not letting me upload photos either. Interesting.

Wrong item was sent. Customer service not answering. No more orders from vevor.

Good luck trying to make a warranty claim productnever workedas intended, tried for over a week to get the issue resolved finally had to dispute the changes with my credit card

This sat in the box for 6 months until I got my shop built and the first time I go to use it, the blade is bent.. right out of the box it was bent. Not to mention that it's grossly underpowered. Don't believe for a second that this thing is 2800 Watts. For $400 I expected at least a straight blade.. Just a word of caution... check this stuff as soon as you get it.. In this case I was straight up ripped off.

Saw blade wobbles and it appears that the shaft is bent I have had difficulty getting a replacement or refund I can’t load the video that shows the blade wobbling and I can’t load the picture that shows the cut in the metal I tested being a 3/8” wide to the blade wobble