Klantbeoordelingen voor VEVOR 274 cm geleidingssysteem voor draagbare zagerijkettingzaagmolen Kettingzaagmolen geleiderail gemaakt van aluminium en ijzer materialen compatibel met diverse kettingzagen en kettingzaagmolens

Works as intended. Great price!

I use this rail system for some small scall timber salvage. It is quick and easy to handle by one person. I had a bit of an issue getting the units to level out at the joins but once it was all straightened out is holds level and works great. I don't use the lag bolts that came with it, I made up some leveling and hold down spikes from some 5/16 all thread double nutted through the holes in the cross members. Works better.

Work and looks like the Granberg. I’ve only had two issues so far. First the bolt are by lock and are not supposed to back off but I’ve had one do it. Second I ordered two and there was no plate for attaching the two together and no option to buy a single set. I order the smaller version from Granberg and it’s a little different but works

The length of the individual rails are shorter than the original and that affects the ability to make it straight. Ideally you want one stiff rail, that's easy to get straigth but that is hard to transport. So it's a compromise. This works for shorter lengths like 1-3m but is not ideal for longer lenghts even if you can make that work too. Quality seem to be good. Delivery also worked fine.

Good product for smaller home projects.

I will start by saying that I have used this product a handful of times and it has done its job. I purchased the vevor chainsaw mill as well. It works well, cuts true, but the nuts they use to hold each section together should be locking. The vibrations for the milling process worked a few of the nuts out and have now returned to the forest. Also the toll they give you is similar to your chainsaw tool, but it is made of very weak metal. When tightening the nuts the tool broke.

Works as it should. Takes a bit of fiddling to level. I added parts two kits together to make longer planks without any problems.

Vomm Prinzip her ein angemessenes Produkt. Die Schraubbolzen sind aber z.b. falsch dimensioniert, wenn man auf flacherem Holz aufsetzen will stehen diese so weit nach oben das die Führung daurch blockiert wird. Die Einschlagbolzen zum Halten könnten an der Spitze deutlich dünner sein, müssen sehr tief eingeschlagen werdewn um zu halten und hinterlassen entsprechende Spuren. Ich persönlich habe statt den Schraubbolzen M8 Schrauben in vwerschiedenen Längen und verwende zum Fixieren statt der Bolzen einfache Schrauben durch vorhandene KLöcher in den Querstreben.

I'm really giving this a 3.5 rating but that's not an option on here. The directions were writen well and had good pictures that identified all pieces. The pieces were also milled well. My complaints are the wing nuts on the bottom. One cannot get them tight enough and some break their welds and the length of the leveling screws. The unit comes with 3inch leveling screw, which with an uneven knotty tree is fine, but I had a very even Ash that didn't require a lot of leveling. All the screws were sticking up above the plane where the saw runs. I had to run to the hardware store and buy 8 2inch screws to make it work. Other than those 2 things I've been milling along just fine and enjoying the easy way it works.

Zu gering dimensioniert die Profile. Die Schiene biegt sich insgesamt zu weit durch. Man muss bei einem gebogenen Stamm zu viel unterkeilen.