Klantbeoordelingen voor VEVOR 19 L vacuümkamer RVS vacuümontgassingskamer (diameter 28 cm, hoogte 30 cm) Negatieve drukpomp vacuümkamer Ideaal voor het stabiliseren van hout en het ontgassen van siliconen, hars, polyurethaan

Looks good, will be tested in upcoming weeks.

Ottimo

Good quality vacuum chamber. I used it for resin degassing. No problems.

Funziona correttamente

parfaitement correspondant à mes attentes. Le montage est très simple, et tout à l'air de très bonne qualité. Je m'en sert pour débuller de la résine ou stabiliser certains bois et jamais déçu. Le nettoyage de la cure au besoin se fait très bien, les joints tiennent bien le choc et les raccords sont toujours parfaitement étanches. Rien à redire.

Ist wirklich beser wi gedacht gerne wieder denke aber das diie lange hält.

This vacuum chamber suits my needs perfectly for casting. Large enough to fit a 16” x 20” piece which is what I was looking for…… and for $350 Cdn, I may just buy another!

Works superb. Almost 0 leak after 24h in vacuum. Better than expected

Good product. Holds vacuum well. Only issue was finding fittings to match those on the hose. I already had a very good vacuum pump.

On receipt, I was not able to get a seal between the lid and chamber without using the small clear split silicone piece on the rim of the chamber. Examination of the chamber top surface showed a small weld line depression that resulted in a leak path. I cleaned and filled the weld line with JB Weld Original epoxy. Now the chamber and orange lid gasket seal very well without the need of the extra clear silicone band. The chamber feels quite heavy duty, as does the 3/4" thick glass lid. The plumbing parts, including the gauge, all sealed well when assembled. The gauge zero'd perfectly when it was 'burped' by temporary removal and reinstallation of the black plug (I don't cut a vent hole in the plug because I often have the gauge upside down and I don't want the glycerin fill to leak). The orange lid gasket does have some less than smooth surface on one side but the other side is smooth all around. The hose connection tends to loosen over time while under vacuum unless well tightened before starting a vacuum run. I am able to pull a gauge reading of 26.5 in Hg at 4000' altitude and, with the valves closed and the pump off, hold it without measurable vacuum loss in excess of 48 hours. I am also able to maintain a leak-free dynamic vacuum for as long as I need to keep the pump running (max to date has been 16 hours continuous). After a number of runs (typically 12 hours / run) with stabilization resin (Cactus Juice), I have not observed any degradation in the orange seal or any of the vacuum line components. With the chamber rim leak fix, this unit is working very well for me.