Klantbeoordelingen voor VEVOR Skid Steer Loader, 1814 kg nominaal vermogen, 1150 mm palletvorkframeverlengingen met 50,8 mm trekhaak en speerhulzen, past op snelkoppelladers, alleen frame

Voor een lichte bobcat is dit een prima vorkenbord. Een setje FEM 2 lepels er bij en je kunt gaan.

Frame is solid and forks easily install. Bolt on top backing is flat stock steel and I expect it to bend on first heavy load test.

Good stuff at a good price.

I bought this a few weeks ago to put on my tractor which has a universal skid steer attach for implements. This one wont seat at the bottom and allow the pins to drop. If it weren't for that its not a bad product. The forks attached fine to it. I have contacted customer service to see what options I have. I've also borrowed a set of forks and frame off a bobcat and it fit perfectly so I know this item is not manufactured to the right specs. I have a Bobcat CT2025.

The backing plate did not fit my case 1840 to begin with, the locking holes were about 1/2 inch off on both sides. Talked with customer service they paid me the amount back to fabricate it to work, thank you for that. The first time I used it to go under a big log to pick it up the lower metal rim where the forks hold on bent. I will have to reinforce the lip. It is LIGHT DUTY for sure. Although CS was helpful I don’t want to go through contacting them again. So for light work absolutely.

Bought this for my farm use put it on my tractor it lasted a few weeks but it is very weakly made metal will bend with very little force!! Totally junk !!! Also bottom bar were your forks connect bends

This frame is useless unless your replacing an existing one. Spike holes are not for common spike and Vevor does not sell Class 2 forks that fits this rack. Regret buying.

This product has a flaw in the build design that causes my forks to not be able to set level with the ground. The build is sturdy but the angle for alowing the forks to lay flat against the ground is way off and has caused me to turn over several stacks of lumber and dump a couple of pallets stacked with material. I have tried to get used to it, but I am not able to overcome this engineering flaw in the fork frame.

item fit and worked well till the bottom lip for my forks bent , and pushed up , will have to cut lower bar loose and add a heavier lip ,and reinforce to the top bar . not impresswd with this purchase, ordered one years ago that had more reinforcing can't find that one available any longer..

This is an overrated piece of equipment. Rated at 2 tons when I tried to pick up a 1,500 lbs of hay it bent it all up. Garbage for sure. It may work ok as a forklift or hitch puller but it sure as he## won’t withstand the weight of a round hay bale. I sent a message to customer service and was basically dismissed, so the moral of the story is if you want heavy duty equipment buy it from a reputable dealer NOT VEVOR. I’ve tried to upload photos but for some reason the porthole won’t let it happen