Klantbeoordelingen voor VEVOR Skid Steer Loader, 1814 kg nominaal vermogen, 1150 mm palletvorkframeverlengingen met 50,8 mm trekhaak en speerhulzen, past op snelkoppelladers, alleen frame

Good quality for a great price.

Great price and great quality Looks just like a John Deere product and the paint even matches as well

Great product, Vevor sells quality products at great prices!

Good stuff at a good price.

I bought this a few weeks ago to put on my tractor which has a universal skid steer attach for implements. This one wont seat at the bottom and allow the pins to drop. If it weren't for that its not a bad product. The forks attached fine to it. I have contacted customer service to see what options I have. I've also borrowed a set of forks and frame off a bobcat and it fit perfectly so I know this item is not manufactured to the right specs. I have a Bobcat CT2025.

The backing plate did not fit my case 1840 to begin with, the locking holes were about 1/2 inch off on both sides. Talked with customer service they paid me the amount back to fabricate it to work, thank you for that. The first time I used it to go under a big log to pick it up the lower metal rim where the forks hold on bent. I will have to reinforce the lip. It is LIGHT DUTY for sure. Although CS was helpful I don’t want to go through contacting them again. So for light work absolutely.

Bought this for my farm use put it on my tractor it lasted a few weeks but it is very weakly made metal will bend with very little force!! Totally junk !!! Also bottom bar were your forks connect bends

This frame is useless unless your replacing an existing one. Spike holes are not for common spike and Vevor does not sell Class 2 forks that fits this rack. Regret buying.

This product has a flaw in the build design that causes my forks to not be able to set level with the ground. The build is sturdy but the angle for alowing the forks to lay flat against the ground is way off and has caused me to turn over several stacks of lumber and dump a couple of pallets stacked with material. I have tried to get used to it, but I am not able to overcome this engineering flaw in the fork frame.

item fit and worked well till the bottom lip for my forks bent , and pushed up , will have to cut lower bar loose and add a heavier lip ,and reinforce to the top bar . not impresswd with this purchase, ordered one years ago that had more reinforcing can't find that one available any longer..