Klantbeoordelingen voor VEVOR 1000x verborgen bevestigingen, afstandhouders voor vlonderplanken, universele composiet T-clips en kunststof bevestigingen met schroeven, geschikt voor plankafstanden van 6,5 mm en plankhoogte van 10 mm

These do not fit the Trex groove. To remedy this, I used a router with a piloted bit to modify the groove on the Trex boards. Worked great after that.

Very good option & price point for these hidden fasteners verses trex brand. I would highly recommend this product, to anyone for composite decking installation. The only thing that should have been offered would be the small metal fasteners for first board and last board. That being said great product for the price.

Clips seemed to spread as screws were tightened. Screw heads stripped easily, then were difficult to get out. Worked, but struggled keeping gaps correct. Found a better product from a different company at nearly the same price.

I purchased this product twice to install my UltraDeck material, 20' x 20'. The PP plastic would seem to be the same material as the product endorsed by the manufacturers that promote Trex and UltraDeck and others that use this style of fastener although the design is slightly different, one "leg" vs. two. My concern is with the screw head. In my opinion the machining of the inter portion where the driver-bit sits is not consistent. When installing these screws you soon learn to start slowly and stay slow. I would set the driver-bit into the screw-head and ensure it was seated properly and then engage the power driver (drill) . Nearly 15% of these screws would start "stripping" right away. I carefully backed the screw out and started with a new one. But in a few cases I had to cut the screw off or remove with a pliers. The screw is a light alloy material and very unforgiving! Despite this issue, cost was the factor, 10 cents each for these versus 30 cents for the other. For a homeowner these are fine but no-way as contractor would I take a chance on these.

The screws come about halfway screwed into the plastic tee. In order to position the fastener over the joist with 2 boards in place, the screw needs to be backed out so it is flush with the bottom of the tee. It takes a few seconds to unscrew the screw but before it is backed out enough to slide, the threads in the tee have stopped and the screw falls out. What was a brief, one handed operation with the Trex fasteners has now become an unwieldy, time consuming process, increasing the installation time by several times.

Too thick for the groove on trex brand decking

Screws are pre set way to far into the clip making it difficult to get the clip set and the plastic is way too soft causing the screws to be easily overdriven.

Didn't work....haven't been able to get my money back. Customer service is not good

Piece of crap, I try only one and the ear crack like a chocolate bar …

I ordered the item.It was lost in shipping I cancelled the order and was issued a return.I received my order 7/8/26 I would like to return