Klantbeoordelingen voor VEVOR magnetische boormachine, 1450W motor, 2-inch boordiameter, 2878 lbf, draagbare elektrische magnetische boormachine met 6 kernboren, boormachine voor metalen oppervlakken, doe-het-zelf

right out of the box the drill was easy to use until we realize it did not have a variable speed switch on it, which makes it very difficult to drill certain things. Overall, the drill is really good qualities better than expected. We would like with the chuck in to be able to put longer drill bits but we’ve worked away around that overall good drill and a way better price.

Easy to use. Not variable speed which is a draw back. Extremely loud to use. Cutters were included which is nice. Ad was a little misleading about speed feature.

It came damaged. We talked to somebody via email about sending us the part and I could fix it but they haven't gotten back to me so I'm stuck in limbo

Don't make the mistake I did.. I over paid for this one. When I got all excited.. Not seeing it was not Variable speed and did not have reverse.. VEVOR helped me out by sending me the variable speed controller. I'm greatful.. Unfortunately the one I bought came in slightly damaged thru shipping.. I should have just sent it back and got the replacement with variable speed and reverse.. Instead of trying to figure out this one.

Cannot use regular twist drill bits, the travel will not allow it, a 1/2 inch bit touches my welding table with drill at the highest point. It came well packaged, I will know better next time.

This drill is advertised as having variable speed which it does not making it more difficult to drill larger holes

Does ok, doubt it will last. Just cheap no good. Vevor is the worst to deal with. Head moves side to side a lot. Would be half ok if you got more bits for the cheaper prices

The fitting drill vs spindle was so tight that it is really hard to mount the drill's. Furthermore the chuck adapter didn't even fit. -Comment - We have confirmed that each spindle is tested before leaving the factory, and only those within the standard range are shipped. If you cannot provide a video of the spindle measurement, we cannot make a judgment at this time. Please try using sandpaper to mark the inside of the spindle to enlarge the inner bore. -Hey, the manufacturer should have fine polished the inside. I think i have to sandpaper down the chuck adapter to make it even go in, phew. Not satisfied at all.

das die Geschwindigkeit der Magnetbohrmaschine sich je nach Belastung ständig ändert ist trotz Wahlmöglichkeit der Geschwindigkeit über Drehrad nicht verständlich. Da auch die Krafteinwirkung/ Höhenverstellung schwer justierbar/ schwergängig ist, ist das Handling nicht wie beschrieben. Die Geschwindigkeitsregulierung macht keine Sinn, da geringe Geschwindigkeiten nicht konstant haltbar sind. Die Maschine läuft zu schnell für die größeren Kronen. Das Beschleunigen überhitzt die Bohrkronen und ist auch gefährlich beim einspannen eines Werkstückes. Der Magnet müsste stärker sein, insbesondere bei dünnen Mat. hat der zu wenig Kraft. Die Imbusschrauben zum einstellen der Maschine sind alle unterschiedlich bzw. scher zu erreichen hinter dem Drehrad... Der Motor ist zu klein dimensioniert und schlecht geregelt. Am Anfang lösen sich permanent alle Bauteile durch die Vibration. An Edelstahl scheitert die Maschine und die Bohrkronen....

Ich habe aus versehen die falsche Maschine Bestellt. Ich wollte sie zurückschicken und die andere Kaufen. Antwort von Ihnen es geht nicht es sei zu Teuer. Habe die Maschine noch nie gebraucht.