Klantbeoordelingen voor VEVOR SDT MD40 magnetische boor met 13-delige 1 inch HSS ringfreesset

Tool holder is 0.004" undersize, so can't load cutters. It'll probably ream out fine. Carriage is aluminum, which is probably a reasonable compromise to get this price point.

Fonctionne pour un usage occasionnel. Attention pas de possibilité de régler la vitesse ce qui en fait un inconvénient majeur.

Drill works great. Annular bits are not very good. One (9-16) broke within 2 seconds. 5/8 cutter won’t cut after 3 holes.

Nu este ca în descriere când dai gaură magnetul se dezlipește nu are suficientă putere

får ikke justert bor hastigheten med denne.

I have had this drill for about one year and have used it 3 times. The last time I used it I noticed a Crack in the body of the drill head. Upon further inspection, I noticed the only thing holding it together was the clamping bolt. When I removed the bolt the casting fell apart. At that time I could see the porosity in the casting that was evident in the machined surfaces and through the coating. This is a defective part and should have been caught in the manufacturing process. This is clearly an inferior product. I'm just thankful I discoved the issue before it caused an injury.

Die Maschine machte auf den ersten Blick einen soliden Eindruck. Leider war bei dem Bohrfutter eine große Beschädigung, man versprach mir ein neues zu schicken. Aber nach ca. 10 gebohrten Löchern kam Rauch aus der Maschine und es roch verbrannt. Mal schauen was Vevor sagt?

első használatba vételkor már elkezdett "síkítós hangon" recsegni ropogni(valószínű darálja a fogaskerekeket), a mágnes ami elméletben 2000 n (kb. : 203,944 kg) erővel húzza magát a vashoz levált szinte azonnal mikor a vashoz ért a 10-es fúrószár, mindezt úgy hogy előtolása mérve is alig pár(max 5-10 kg) kg volt. egy romhalmaz az egész. még nem adta fel a harcot, de biztos az lenne a vége ha folytatnám a használatát. A megvételét ssenkinek nem ajánlom. When first used, it started to crackle with a "squeaking sound" (it's probably grinding the gears), the magnet, which in theory pulls itself to the iron with a force of 2000 N (approx.: 203.944 kg), came off almost immediately when the 10-mm drill bit touched the iron, all this while its feed was barely a couple (max 5-10 kg) kg. The whole thing is a pile of rubble. It hasn't given up the fight yet, but that would definitely be the end of it if I continued using it. I don't recommend buying it to anyone.

Bonjour, j'ai reçu votre perceuse, j'ai perce 4 trous de 45 mm et la perceuse à fumée Elle ne tourne plus et fait disjoncter le général Je suis dans l'attente d'une pièce pour la garantie plus de trois semaines, vraiment déçu J,attends après vous I

I had a problem with the drill and i contacted vevor and explaned the problem and i never heard back from them.