Klantbeoordelingen voor VEVOR 13,8-tons hydraulische bandenlichter, 10.000 psi bandenmontagetechnologie, 12,7 cm hydraulische bandenlichter, hydraulische bandenlichter

lourd à mettre en place,mais d'une redoutable efficacité!!!

love it. works great its awesome.

tres bien

Super matos Rien à redire

I bought this for a difficult job. Some old hard offroad tires. Eventually it did "help" with it, but it certainly wasn't a magic answer. The feet on it do not line up. This makes it impossible to push in between the rim and the bead. I pulled the two fixed feet off and milled about 180 thousandths off to get them close, and then slightly narrowed the leading edges of all three feet with an angle grinder. On soft rubber tires that weren't stuck in place that might have been enough, but for my application it was not. I had to partially upset the beads with a slide hammer breaker, and then HAMMER in the feet for the hydraulic bead breaker. At that point I stepped on the pedal and waiting around sipping on my coffee while it chugged away finally popping the bead off in one location. On every tire on each side, I had to press with the hydraulic bead breaker in three places each next to the last in order to get the bead to fully pop off. It was a lot of work, but I expect a tire company machine would have struggled too. Would I buy it again knowing what I know now. Maybe. The amount of time I spent would have easily paid for the cost of taking them to somebody else even if they charged extra because it was such a tough set of tires to remove. On other tires though I can see it being useful.

Foarte multumit de calitate pret al produsului si livrarea a fost rapida . Multumesc Vevor pentru promtitudine .

I've only used the three fingered willy once it worked great. The air pump I've used quite a bit with my enerpac portapower and it had done awesome, much nicer than pumping by hand.

What an excellent machine. I have an antique/old 1980 23,000 pound loader/backhoe. The rear tire measures 4.00 x 25, 20 Ply. The bead was rusted only to split rim. Once we could get the bead separated enough to insert the Bead Breaker we could move the bead away some. By slowly moving around the rim the Bead Breaker removed rim from the bead. The Inner tube was replaced. The rest was only to sandblast the rim and repaint for re-installation. Yes, I'm impressed with this Bead Breaker

matériel corespondant a mes attentes, facile a mettre en œuvre et très efficace, matériel acheter pour démonter des pneu arrière de tracteur agricole et pneu avant de 4x4ce qui m’évite d'avoir a démonter les pneus et les jantes

Great price going to pay for itself first use. Little heavy and bulky but built solid. Like how I can disconnect the air over hydraulic pump for other attachments if desired.