Klantbeoordelingen voor VEVOR Tegelsnijder Dubbele Rail Snijlengte van 1200mm, Snijdikte 4-15mm Minimale snijbreedte 25mm Tegelsnijmachine Inclusief Extra Snijwiel voor Tegelleg- & Renovatieprojecten

La he usado con porcelánico de 1,20 m, y con pasta blanca de 0,90 m. En los cortes largos de 1,20, se nota que pandea bastante conforme vas cortando, aún así he sacado piezas a lo largo entre 2 y 3 cm sin mucho problema. Para cortes mas pequeños corta muy bien y sin problemas.

La maquina en si va bien hay cosas que mejorar como las patas de apoyo son muy sencillas tenian que ser de metal y por lo menos poner como opcion una bolsa de transporte o una caja la escuadra tambien es sencilla el laser mal calibrado tube que regularlo yo menos mal que lleva tornillos para ajustar por lo demas bien

Envio fora de prazo e sem rastreio. A máquina de corte de cerâmica manual chegou com defeito nas borrachas dos apoios laterais, enviei fotos da situação e estou a aguardar que enviem substituição da peça com defeito.

Looks good at first but actually poorly built.. still does the job but wouldn’t buy vector tool again

Funciona bien un par de meses, después solo podré cortar unos 50 cm. , pienso que estructura bastante floja y dobla

I bought this to cut large format tiles, 24 x 48. I have several smaller cutters. The trend to larger tile sizes forced me to get a new bigger one. The packaging looks good on the outside. However when I set it up and started using it I quickly realized it was going to be a challenge to get the job done correctly. One of the biggest gripes I have is they didn't calibrate the tool. There maybe a laser mounted on the head but as is out of the box it's useless. You will need to adjust it. Then I put a tile in and scored it, pressing the snap bar separated the two halves. pull it out from the bed and how off square could it be? Try 1/8" per foot. That is ridiculous. The rails seem too thin for the length that they are. The car slides nicely. There are these wings on the sides to support tile overhang. They are flimsy are get in the way if you're not using them. The unit is put together with nylock bolts and screws. Put aside 3 hours to setup and calibrate. It's not ready to use as is out of the box. Would look elsewhere for a more robust accurate tool.

Not stable then cutting, often makes curved cuts -3-5mm on the middle

Le colis est arrivé cassé. J'ai fais une réclamation j'attends le retour du SAV.

No recomiendo no reliza bien el corte

Wat een vreselijk product! Ik heb het maar één keer gebruikt en het maakte mijn werk alleen maar moeilijker. Een terugbetaling zou geweldig zijn.