Klantbeoordelingen voor VEVOR Professionele Tafelbankschroef Precisiebankschroef 3 Inch 80mm Bankschroefklemmen Gereedschapsset Bankklem

super

Der Schraubstock besteht aus einem guten Material (vergüteter Stahl) und ist mechanisch gut verarbeitet. Der Planschliff ist ebenfalls gut. Gut einsetzbar für ein genaues Arbeiten. Preislich könnte er einen Ticken niedriger (in den 60ern) sein aber noch noch okay. Insgesamt Gut 👍

Buena prensa de precisión buen material muy practica y confiable utilizada ya en varias operaciones de taladrado y fresado muy satisfecho con la compra

Fin maskinstikke. Mye for pengene. Fungerer helt fint til mitt hobbybruk. Kjøpte først en. Anbefalte og kjøpte en til min bror også.

Contrairement à la table croisée Cf. mon commentaire),, cet étau n’a aucun jeu et est prêt à l’emploi.

I gave this vice 5 stars because i think it is well worth the money for what it is. I'm using it on a 6x26 knee mill to hold parts that are just a little too big for my 4". It was easy to indicate in and is flat to the table. Again, for the money I think it is well worth it. Like all imports, it needs a good cleaning and deburring but completely acceptable for hobby work.

Excellent product, beautifully manufactured and fits well on my milling machine,. recommend Vevor to trade with.

trés correct pour le tarif

Superbra till priset

TL-DR: I'm overall satisfied because I expected that the price meant I was getting a fairly decent casting, machined and ground that requires further cleaning, deburring and refinement. The paint is very decent and overall surface finish more than decent. - Received promptly in good condition by pure luck since there is ZERO protection in the box. - No rust on mine*, only grime and machining swarf and some sticky oil/grease partially dry. - *Not everything is coated and in a cold climate, it got full of condensation. Unpack, degrease and clean and coat with WD-40 immediately.* All the immediately visible machined surfaces look good, but EVERYTHING needs cleaning and DEBURRING. A complete teardown shows some casting defects (minor) and not as good machining where it is "hidden", and more involved deburring and filing is needed to address that. ***The nut that sets the pressure against the thrust bearing for the lead screw has 2 set screws which damage the threads. - The bearing and leadscrew need to be cleaned and re greased. - Yes, one can use it out of the box, it works, but it will probably grind itself over time and even draw blood when handling. Conclusion: After a couple of hours of tearing down, cleaning, deburring, filing some casting excess, filing the damaged threads near the handle, some wire wheeling and polishing, a nice waxing of all the non moving surfaces and oiling and re-greasing the leadscrew+ Nut and bearing, it works flawlessly.