Klantbeoordelingen voor VEVOR Water Wijn Distilleerder, 2,5 GAL Water Brouwen Kit, Roestvrijstalen Splinte Moonshine Still, Koperen Buis Alcohol Distilleerder Spirits Kit, Ingebouwde Thermometer voor DIY Whisky Wine Brandy

it was a gift and thay are just learing . and looking for recpice

It works cyclically. You set it to 95 degrees, it works, at 95 degrees 50 liters it pauses, the distillate doesn't flow and when it starts it flows like a tornado. You can't distill alcohol with this mess.We threw out your setting system and installed a 220V / 5000W Voltage Regulator in its place. It works very well at the set degrees.You are cabbage.

Missing part still waiting for missing item Useless no quality control in packaging

Blew the lid off of it. Scrap metal. I don't know if I would even take another one for free.

Some of the components ( plastic steam pressure valve ) are not adjusted for high temperature ( made of plastic materials )

This setup gives Some value for money for somebody who wants to try what distilling is. But the quality of the copper is not that good and the cooler and cool are too small, so if you like the hobby, fast you are going to want a better setup. But this one is fine to give it a try and make a descent product.

Little awkward to set up but it does the job

Your stills are good with some upgrades to size of thumper, condenser and size of connections and coil. I already had one of your 5 gallon stills and completely re built it. Then I needed a bigger still pot so I got your 13 gallon and am using my 5 gallon as the thumper all re done with 1 inch copper pipe connections and 20 feet of 1 inch copper coil in a 10 gallon cooler for my condenser.

Pas mal fait, mais le bocal refroidisseur et trop petit et mal placé, il se réchauffe trop vite. J'ai dû racheter un refroidisseur et du tube pour l'éloigner

Hallo, leider ist die Distille eine absolute Katastrophe: Die Kupferspirale und Kupferrohre sind falsch dimensioniert, sodass der Topf mit dem Kühlwasser nicht mittig zum stehen kommt. Aber selbst wenn das der Fall wäre, würde der Topf nicht zwischen den Auslass und der mitgelieferte Thermometer passen. Also stand der Kühlwassertopf bei meinem ersten Brennvorgang irgendwie über den Rand hinaus, was dazu führte, dass sich der Boden des Maischebehälters total verformt hat und nachher nur noch auf deiner Seite Kontakt zum Herd hatte.