Klantbeoordelingen voor VEVOR Vorkverlenging Stalen heftruck 1000kg Laadvermogen CAT1/CAT2 Montage 78x61x25cm Palletwagen 20kg Hefpallet 3-punts aansluiting Geschikt voor alle transport- en expeditievoertuigen

I bought these forks because they looked like a perfect fit for my New Holland tractor. Looked perfect when unpacking however I ran into a problem. When trying to attach my lower control arms I found the holes drilled on the bracket were too close to the frame of the fork attachment. I could not put the pin in, the holes should have been an inch farther from the frame. Not sure if I should return or remove and weld on new steel brackets that are a little longer. I willl attach the picture. I the lower arm will be beside the bracket for the picture to show distance is not large enough

I bought these back I September 2026. Do to injuries. I just opened these on November 6th. Looks great, well built. Just missing parts. I got the 4000 lb set. 2 screws per fork. I only recieved 2 bolts. I can use them with out the other screws. I don't want to damage the forks, or my bucket. Hopefully Vevor will step up and send me the missing parts.

Love these forks. I also bought the fork extensions, vevor needs a set fork the bucket forks. I modified mine. See the photo below.

attache sur les bras de relevage trop courte, attache des fourche trop fragile

They do the job, but one of the center bars bent too easily, and now I have to fix it to bend it back into place. The clamps loosen up easily. I would not buy again.

Die Gabel selbst hält die 1000kg vielleicht aus aber nicht die CAT1/CAT2 Bolzen. Habe damit ca. 400kg gehoben und die Bolzen sind verbogen.

OK for price but cross member broke on first use. will have to weld on stronger box section

Theses are nice but not safe for heavy loads while attached to you tractor bucket. Causes to much weight in the front

The center bar broke right away other than that work well

Had high hopes that these would work for doing some lifting of pallets with my Kubota 7800. Tractor had no problem lifting, but the screws on the other hand both had issues. Both bent to a point I can't get them out to replace and one fork bent where I attached a chain to improve stability, the chain bent the metal. Yes I screwed the fork to the bucket and then tightened the bolt. Yes the forks were fully inserted onto the bucket.