Klantbeoordelingen voor VEVOR Elektrische Lier 13500LBS 12V Winch Elektrische Stalen Kabellier Aanhangwagen Stalen Touw Tandwieltrein Goed

So far it's good

Bestelling op tijd en onbeschadigd ontvangen. De lier was eenvoudig te monteren en wordt al een paar weken gebruikt voor houtkap en om uit de modder te komen bij de 4x4-club. Voor de prijs doet de lier wat hij moet doen. Ik kan hem van harte aanbevelen.

Commande reçu dans les temps sans dommages.Treuil facile à monter ,utilisé pour du débardage de bois et service franchissement et sortie de bourbier club 4*4 depuis quelques semaines.Pour le prix le treuil fait le job.Je recommande vivement.

Hyvin toimii, vähän paksunlainen vaijeri mutta purkautuu kyllä kelalta kun auttaa kaukosäätimellä.

Super treuil avoir dans le temps....

Arrived a day early, but package slightly damaged. Review requested within2 hrs of arrival before even unboxed. It's a heavy brute. A wire in the control box appears to broken or not connected. At 1.8m the main power wire is too short to reach power source in my application. The mounting plate referred to in manual should really be included in package rather than an additional purchase. Haven't been to try it as yet.

Use it on my roll off trailer. Though it does work and hasn’t left me stranded YET. It does seem to struggle a little bit straight pulling 8k pounds

This is the second one I have bought. The1st is on my Dodge works great. The second I put on my jeep. I expect the same.

I have used this winch and it works great. Only 4 stars because there was a part missing when I received it. They did a great job of taking care of the problem

I will mount this winch this weekend and will give it a try then, but be warned that in order to mount it, you will need special nuts--the bottom holes are not threaded, but rather have slots into which a nut would go, but they're too wide to hold standard 3/8" nuts captive. Sooo, in order to make it work, I picked up some rectangular nuts that are normally used on Unistruts and used an angle grinder to grind them down until they fit. Including the nuts and bolts would be a huge help, Vevor! Also, the pictures suggest that the fairlead can be mounted on the winch without any accessories, but that's not the case--I had to head to Harbor Freight to buy a fairlead mount. Between that mount, the Unistrut nuts, and my time to make the nuts fit, the low cost of this unit wasn't actually so low. I assume the winch itself will work well, but it not I'll add to my review.