Klantbeoordelingen voor 8 Gallon Druktoevoer Verf Pot Tank Spuitpistool Sproeier Regelaar Luchtroerder

I ordered the smaller 10l pressure pot from Vevor. It seems designed for resin casting but still has a paint pipe installed in case you want to spray paint. This gets in the way of casting. I think Vevor should remove it. I did - with an angle grinder. I couldn't unscrew it. The pot works fine up to 50 psi (which is high as I need to go). No bubbles in the resin. No leaks from any point on the pot either, so no need for the supplied sealant. For £114, this pressure pot is way cheaper than the competition. I didn't find any CE quality marks and I haven't tested the safety pressure release (60psi) but it works well. If Vevor supplied castors the price would be a little higher, but I think they could remove the paint pipe (as an option?) or blank off that fitting without a major cost and sell it for the purpose most purchasers will use it for - resin casting. It would be good if they supplied an adjustable caddy as well as the internal base plate. Overall however, I'm very satisfied.

good quality great value, well built and hoping for many years use, have been always haappy with items bought from vevor

I got this to convert into a pressure pot for resin casting as it’s the same as the widely referenced Habour Freight pressure pot that a lot of American YouTubers recommend. Getting the parts off was a bit of a hassle as they’re sealed with glue, so I has to resort to a blowtorch to melt the glue in order to remove the fittings. The T pieces are junk and leak even with ALL the PTFE but the rest is sound. Pressures nicely to 55psi without issue. Recommended.

Does what it’s supposed to and made work easier

I bought this to make a pressure pot for resin casting. Build quality is excellent for the price and by spending a couple of quid on fittings it’s up and running and holding pressure for 24 hours.

Brilliant bit of kit. I converted it into a resin casting pressure pot, the paint extraction pipe and paint agitator all unscrew so all that’s needed is a bolt with 2 metal washers and 2 rubber washers for where the agaitator pipe goes.It’s sits it about 45psi comfortably without the air compressor attached, so the resin can cure overnight.Extremely happy with the product

You will need to buy an air compressor to be able to use this pressure which it's not mentioned in the description. This product is shipped from china which is impossible to send back once you need to for whatever reason. And it will be on your own costs. Customer service is simply bad. Be aware before you buy it.

Good bit of kit, sturdy & seems to be well made. I've converted it into a pressure pot for resin casting, holds the pressure after capping off the outlet & fitting a tap to the inlet.

Great quality pressure pot made sturdy, easy to use handy with the lift out stainless Steel pot ,long may it last

i bought this for £70 on the vevor site with free delivery (even got £5 off because it was my first order from them) and even though i havent used it yet it seems like its pretty much set up to be used for resin (i think) as all you need to do is buy a cap for the elbow to stop the air escaping